+

"OE" Chain MOTO - Accessories & Tools

Dove sei: Homepage > Motorcycle > Prodotti > "OE" Chain MOTO - Accessories & Tools

 

WARNING CHAINS "OE" with pre-code 10 ARE LOW AND WILL BE REPLACED WITH THOSE "TROFEO" with pre-code 20 as shown in the code column new !

 

ROAD STANDARD

ROAD PROFESSIONAL

SUPER ROAD - SPORT

OFF-ROAD

STANDARD

When a chain for motorcycle use is classified as STANDARD, it means that it corresponds to the traditional processing degree of the industrial chain. That is, there is no trickery or sophistication involved in its components.

OFF-ROAD

H series 

ROAD

HO: PROFESSIONAL O-RING

Description: chain with traditional O-ring, for medium engine capacity enduro and road motorcycles. This system with two lubricant deposit areas, typical of sealed chains, allows 20% longer durability than a chain without an O-Ring; 

Features: 30CrMoTi steel pins, solid bushing;

HX: PROFESSIONAL H-RING 

Description: chain with exclusive H-Rings for medium and high engine capacity enduro and road motorcycles. Thanks to the particular profile with four-point contact, the friction on the entire transmission is reduced by 40% compared to a chain with a traditional O-ring; 

Features: 30CrMoTi steel pins, solid bushings;

SUPER ROAD O-RING

Description: chain developed for super-powerful road motorcycles, with very high operating and torque loads. The use of new materials and sophisticated heat treatments of the external plates make this type of chain more resistant to wear, ensuring approximately 30% more than a professional O-Ring chain 

Features: 30CrMoTi steel pins, solid bushings, reinforced plates

INSTRUMENT FOR CHAIN LENGTHENING CONTROL

A new GAUGE is available, which allows the practical and quick verification of chain lengthening over 2%. 

Suitable for chains of: 

- 1/2 inch (415-420-428) 

- 5/8 (520-525-530-532) 

- 3/4 (630-632) 

- 1 inch 

FOR INDUSTRY AND MOTORCYCLE USE it can be ordered with the following code 52 9510 001 see attachment for further information. 

calibro2-ita-ing.pdf

commerciale@ognibenechaintech.it

CHAIN LUBRICANTS

We tested several spray lubricants, which are largely marketed and are specific for motorcycle transmissions, detecting poor lubricating efficiency or excessive centrifugation. They can be considered suitable only for protective purposes against the weather or with low operating loads. For this reason, for long motorway distances, high power, extreme classified stresses and for a long duration, we recommend only the DID or OGNIBENE SPRAY and the relative detergent.

Availability:

1.50 ml OE lubricant spray code 10 9511 000 

2. 400 ml OE lubricant spray code 10 9513 000 

3. 400 ml OE lubricant spray code 10 9514 000 

4. 400 ml OE detergent spray code 10 9512 000 

 

 

 

 

SINGLE USE CHAIN TOOL

10 9510 000 5/8 chain closing single-use pocket tool for ZJ joint with drilled pin.

INSTRUCTIONS:

10-9510 attrezzo chiusura catena.pdf
10-9510 chain closing tool.pdf

 

 10 9505 000 single-use chain pin extractor pocket tool for riveted joint:

 

Tutti i prodotti Ognibene, sezione Motorcycle